Ian10gx40
IMG_20191006_194218.jpg see photo above
At the moment I have only got as far as putting 2 x cobalt up digital motors on the layout
The plan was to work from the fiddle yard outwards testing as I go and adding the other motors as I go. 
All was working OK but now the 2 motors fitted have stopped working
When I press the push buttons
007 or 008 appear on the display momentarily then goes out
The Led shown is lit all the time and nothing happens
This is connected from control panel to motor via common bus wires also used on the NCE system
Any ideas????? 
Quote 0 0
AHJAY
HI

impossible to diagnose from a post, but its likely something very simple. Call and ask for John if today, John or Mick if tomorrow. They can talk it through with you

regards, Ahjay
Quote 0 0